Excell PWZ0163100.02 Troubleshooting Guide download pdf (Page 11)

11 - ENG

OPERATING INSTRUCTIONS (CONT.)

• SAVE ALL INSTRUCTIONS

STARTING

Prior to starting, refer to your engine manual for

proper starting procedure.

1. In a well ventilated outdoor area add fresh, high

quality, unleaded gasoline with a pump octane rating

of 86 or higher. Do not overll. Wipe up spilled fuel

before starting the engine. Refer to Engine Owners

Manual for correct procedure.

2. Check engine oil level. See Engine Owners Manual

for correct procedure.

3. Connect the water hose to the water source. Turn

the water source on to remove all air from the hose.

When a steady stream of water is present, turn the

water source off.

4. Verify the lter screen is in water

inlet of pump. (Fig. 10)

NOTE: Cone side faces out.

5. Connect water source to pump inlet. NOTE: Water

source must provide a minimum of 5 gallons per minute

at 20 PSI. (Fig. 11)

WARNING

To reduce the possibility of con-

tamination always protect against back ow when

connected to a potable water system.

6. Connect high pressure hose to pump outlet.

7. If applying a chemical or cleaning solution, see

How To Apply Chemicals/Cleaning Solvents instructions

in this section.

8. Insert the quick connect nozzle for the task being

performed. See How To Use Wand instructions in this

section.

9. Turn water source on.

CAUTION

RISK OF PROPERTY DAMAGE. Failure

to do so could cause damage to the pump.

10. Remove all air from the pump and high pressure

hose by depressing trigger until a steady stream of

water is present.

11. Start engine. See Engine Owners Manual for correct

procedure.

WARNING

RISK OF UNSAFE OPERATION. If

engine does not start after two pulls, squeeze trig-

ger of gun to relieve pump pressure. Pull starter cord

slowly until resistance is felt. Then pull cord rapidly

to avoid kickback and prevent hand or arm injury.

12. Depress trigger on gun to start water ow.

WARNING

RISK OF UNSAFE OPERATION.

Stand on a stable surface and grip gun/spray wand

rmly with both hands. Expect the gun to kick when

triggered.

13. Release trigger to stop water ow.

DANGER

RISK OF INJURY FROM SPRAY. Al-

ways engage the trigger lock when gun is not in use. Fail-

ure to do so could cause accidental spraying.

SHUTTING DOWN

CAUTION

RISK OF PROPERTY DAMAGE. Failure

to do so could cause damage to the pump.

1. Turn engine off. See Engine Owner’s Manual.

CAUTION

RISK OF PROPERTY DAMAGE. NEVER

turn the water off with the engine running.

2. Turn water source off.

3. Pull trigger on spray gun to relieve any water

pressure in hose or spray gun.

4. See Storage section in this manual for proper storage

procedures.

FIG. 11

FIG. 10

Filter Screen

High-Pressure

Hose Hook-up

Water Source

Trigger Lock Engaged

FIG. 12

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 112 113

Comments to this Manuals

No comments

Excell PWZ0163100.02 Troubleshooting Guide Page 11

Comments to this Manuals

Related products and manuals for High-pressure cleaners Excell PWZ0163100.02